我们的网站为什么显示成这样？

可能因为您的浏览器不支持样式，您可以更新您的浏览器到最新版本，以获取对此功能的支持，访问下面的网站，获取关于浏览器的信息：

|本期目录/Table of Contents|

机电引信串联和并联模型可靠性评估方法(PDF)

《探测与控制学报》[ISSN:1008-1194/CN:61-1316/TJ]

期数:
2009年06期
页码:
51
栏目:
出版日期:
2009-12-26

文章信息/Info

Title:
Reliability Evaluation for Electromechanical Fuze Based on Series Model and Parallel Model
文章编号:
1008-1194(2009)06-0051-04
作者:
周平; 牟洪刚; 刘勇; 张乐
西安机电信息研究所，陕西 西安710065
Author(s):
ZHOU Ping; MOU Hong-gang; LIU Yong; ZHANG Le
Xi’an Institute of Electromechanical Information Technology,Xi’an 710065,China
关键词:
高价值弹药; 机电引信; 可靠性框图; 可靠性评估
Keywords:
high-value ammunition; electromechanical fuze; reliability diagram; reliability evaluation
分类号:
TJ43
DOI:
.
文献标识码:
A
摘要:
在高价值弹药机电引信研制中，由于产品成本高，不能像常规弹药引信通过大量的试验对产品可靠性进行验证，因此只有通过可靠性评估对产品的可靠性进行确认。针对这个问题，提出了一种高价值弹药机电引信可靠性评估方法，即将机电引信分为电路部分、机构部分和爆炸序列等几大部分分别进行可靠度评估，然后通过串联模型进行综合计算出引信单路子系统的可靠度，最后通过并联模型计算出整个引信的可靠度。通过实践验证，证明了评估方法有效、可行，对以后高价值弹药机电引信可靠性评估的研究具有一定的借鉴意义。
Abstract:
In the development of electromechanical fuze of high value ammunition,the product reliability can not be verified through a number of tests because of the high cost,so the product reliability should be verified by using the reliability evaluation.Therefore,reliability evaluation method for electromechanical fuze of high value ammunition is put forward in this paper.The electromechanical fuze can be divided into the parts of circuit,mechanism and explosive train which would be evaluated respectively.Then the reliability of fuze circuit sub-system is obtained through comprehensive calculation by series model,and the reliability of fuze system is obtained through the calculation by parallel model.The practical verification shows that the evaluation method is effective and feasible,and it also can be a reference for the research on reliability evaluation for electromechanical fuze of high value ammunition in the future.

参考文献/References

［1］王炜,蔡瑞娇,焦清介.制导弹药可靠性评定方法的研究［J］.兵工学报,2007,28(7):41-45.
WANG Wei,CAI Rui-jiao,JIAO Qing-jie.Study on reliabilityevaluation methods of guided ammunition［J］.Acta Armamentarii,2007,28(7):41-45.
［2］王军波,王玮,常悦,等.高价值弹药引信小子样贝叶斯可靠性评估方法［J］.探测与控制学报,2009,31(1):57-60.
WANG Jun-bo,Wang wei,CHANG Yue,et al.A Bayes Method of Small Sample Reliability Evaluation for High-valued Ammunition Fuzes［J］.Journal of Detection & Control,2009,31(1):57-60.
［3］周涛,胡昌华,叶雪梅.导弹武器系统可靠性评估的Bayes方法［J］.战术导弹技术,2005,(1):20-22.
ZHOU Tao,HU Chang-hua,YE Xue-mei.Study on Bayes evaluation for reliability of missile weapon system［J］.Tactical Missile Technology,2005,(1):20-22.
［4］李东兵,王力强,潘鸿飞.武器装备系统可靠性工程综述［J］.战术导弹技术,2003,(6):12-20.
LI Dong-bing,WANG Li-qiang,PAN Hong-fei.Comment on reliability engineering in weapon system［J］.Tactical Missile Technology,2003,(6):12-20.
［5］李良巧主编.产品可靠性基础［Z］.北京:中国兵器质量与可靠性研究中心,2008.

备注/Memo

备注/Memo:
*收稿日期：2009-10-28
作者简介：周平(1965-)，男，四川成都人，硕士，高级工程师，研究方向：机电引信设计。E-mail：zhouping21285@sohu.com。
更新日期/Last Update: 2010-01-07